To Next PageTo Next PageTo Previous PageTo Previous Page
Loading...
Need help?Do you have a question about the Cisco RV260P and is the answer not in the manual?
General| DHCP client | Yes |
|---|---|
| Routing protocols | RIP-1, RIP-2, RIPng |
| Supported protocols | PPPoE, PPTP, IGMP, RSTP, DynDNS, No-IP, ChangeIP, NAT, PAT |
| IPv4 & IPv6 features | Dual stack IPv4/IPv6 |
| Link layer protocols | L2TP |
| DSL WAN | No |
| VPN support | Client-to-gateway IPsec VPN, IPsec VPN, PPTP VPN, OpenVPN, VPN pass-through |
| Firewall security | SPI firewall, Port forwarding and triggering, Denial-of-Service prevention (DoS) |
| Security algorithms | 3DES, 128-bit AES, 192-bit AES, 256-bit AES, HTTPS, IPSec |
| VPN tunnels quantity | 20 |
| Throughput | 0.8 Gbit/s |
| Cabling technology | 10/100/1000Base-T(X) |
| Networking standards | IEEE 802.1p, IEEE 802.1x |
| Ethernet LAN data rates | 10, 100, 1000 Mbit/s |
| Ethernet interface type | Gigabit Ethernet |
| Safety | UL 60950-1, CAN/CSA-C22.2 No. 60950-1, IEC 60950-1, EN 60950-1, FCC Part 15.247, 15.407, RSS-210, EN 300.328, EN 301.893, AS/NZS 4268.2003, FCC Part 15.107, FCC Part 15.109, ICES-003, EN 301.489-1, EN 301.489-17 |
| Operating system installed | Linux |
| Product color | Black |
| LED indicators | LAN, Power, WAN |
| Combo SFP ports quantity | 1 |
| Ethernet LAN (RJ-45) ports | 8 |
| Power over Ethernet (PoE) ports quantity | 4 |
| Input current | 1.67 A |
| Output voltage | 54 V |
| Power source type | DC, PoE |
| Storage temperature (T-T) | -20 - 70 °C |
| Operating temperature (T-T) | 0 - 40 °C |
| Storage relative humidity (H-H) | 5 - 90 % |
| Operating relative humidity (H-H) | 10 - 85 % |
| Package type | Box |
| Package depth | 261 mm |
| Package width | 435 mm |
| Package height | 106 mm |
| Package weight | 2720 g |
Weight and Dimensions| Depth | 170 mm |
|---|---|
| Width | 279.4 mm |
| Height | 38.5 mm |
| Weight | 1260 g |
