4 Cisco Unmanaged Rackmount Switches
To mount the unmanaged rackmount switch to the wall:
STEP 1 Determine where you want to mount the unmanaged rackmount
switch. Verify that the surface is smooth, flat, dry, and sturdy.
STEP 2 Drill two pilot holes into the surface 3.74 inches (95 mm) apart, and
with a minimum of 5.12 inches (130 mm) of clearance.
STEP 3 Insert a screw into each hole, leaving a gap between the surface
and the base of the screw head of at least 0.1 inches (3 mm).
STEP 4 Place the unmanaged rackmount switch wall-mount slots over the
screws and slide the unmanaged rackmount switch down until the
screws fit snugly into the wall-mount slots.
276583
To Next Page
Loading...
Need help?
General
