Cisco Unmanaged Rackmount Switches 3
Rack-Mount Placement
Follow these steps to rack-mount the switch in any standard 19-inch rack.
STEP 1 Place the switch on a hard, flat surface with the front panel facing
towards you.
STEP 2 Attach a rack–mount bracket to one side of the switch with the
supplied screws and secure the bracket tightly. Repeat this step to
attach the other bracket to the opposite side of the switch.
STEP 3 After the brackets are attached to the switch, use suitable screws
to securely attach the brackets to any standard 19-inch rack.
Wall Mounting
A Cisco SF 100-16, SF 100-24, SG 100-16, or SG 102-24 Unmanaged
Rackmount Switch can be wall-mounted.
If you plan to mount this switch to a wall, you need 2 wallboard screws to
deploy the unmanaged desktop switch. We recommend using screws with
a minimum of 0.27 inches (6.8 mm) width at the head and at least 0.69
inches (17.6 mm) long. Depending on your mounting surface, you might
require longer screws or drywall anchors with a minimum of 0.31 inches
(8 mm) width at the head and at least 0.87 inches (22.2 mm) long.
WARNING Insecure mounting might damage the device or cause injury.
Cisco is not responsible for damages incurred by insecure wall-
mounting.
1234 5678 9101112
13 14 15 16 17 18 19 20 21 22 23 24
miniGBIC1
(Share
d with 12) (Shared with 24)
miniGBIC2
Cisco Small Business
SR2024
24-Port
10/100/1000 Switch
1 2 3 4 5 6 7 8 9 10 11 12 /
miniGBIC1
Link/Act
Gigabit
Link/Act
Gigabit
SYSTEM
13 14 15 16 17 18 19 20 21 22 23 24 /
miniGBIC2
193086
To Next Page
Loading...
Need help?
General
