Cisco SPA122 Provisioning Guide

3
Provisioning Guide for Cisco SPA100 and SPA200 Series Analog Telephone Adapters
In-House Preprovisioning and Provisioning
Servers
Cisco IP Telephony devicesSPA100 and SPA200 Series ATAs, other than RC units,
are preprovisioned by the service provider with a profile. That pre-provision
profile can range from a a limited set of parameters that resynchronizes the ATA to
another profile with a complete set of parameters delivered by remote server. Or, it
can be a complete set of parameters. By default, the ATA resynchronizes on
power up and at intervals configured in the profile. When the user connects the
ATA at the customer premises, the device downloads the updated profile and any
firmware updates.
This process of preprovisioning, deployment, and remote provisioning can be
accomplished many ways. This chapter describes the features and functionality
available when preprovisioning these ATAs in-house and provisioning them
remotely:
• Server Preparation and Software Tools, page 38
• In-House Device Preprovisioning, page 39
• Provisioning Server Setup, page 40
Server Preparation and Software Tools
The examples presented in this chapter require the availability of one or more
servers. These servers can be installed and run on a local PC:
• TFTP (UDP port 69)
• syslog (UDP port 514)
• HTTP (TCP port 80)
• HTTPS (TCP port 443).

Cisco SPA122 Specifications

General

Brand	Cisco
Model	SPA122
Category	Adapter
Language	English