Cisco TELEPRESENCE MANAGEMENT SUITE User Manual

Configuring the Cisco TelePresence Management Server
Cisco TelePresence Management Suite Installation and Getting Started Guide Page 31 of 70
Connecting cables
LAN cable
Connect a LAN cable from the ‘LAN 1’ connector on the Cisco TelePresence Management Server
Appliance to your network. The LAN 2, 3 and 4 connectors are not used and are left open.
Power cable
Connect the system power cable to an electrical distribution socket. Press the power switch button at
the back to ‘1’. The power indicator LED, marked ‘Pwr’, on the front panel lights up.
Note: It is recommended that the Cisco TelePresence Management Server is shutdown via the front
LCD panel or from the Windows interface before powering the unit off.
Connecting a Monitor and Keyboard (Optional)
Initial network configuration is done via the LCD Panel. After configuration, a VGA monitor, USB
keyboard and mouse can be used to access the server console.
IP address configuration
The Cisco TelePresence Management Server Appliance requires an IP Address before it can be used
and this is done using the LCD panel:

Cisco TELEPRESENCE MANAGEMENT SUITE Specifications

General

Brand	Cisco
Model	TELEPRESENCE MANAGEMENT SUITE
Category	Software
Language	English