To Next Page

To Previous Page

-Location of horizontal USB socket on

motherboard

Enabling or Disabling the Internal USB Port

The factory default is that all USB ports on the server are enabled. However, the internal USB port can be

enabled or disabled in the server BIOS.

Step 1 Enter the BIOS Setup Utility by pressing the F2 key when prompted during bootup.

Step 2 Navigate to the Advanced tab.

Step 3 On the Advanced tab, select USB Configuration.

Step 4 On the USB Configuration page, select USB Ports Configuration.

Step 5 Scroll to USB Port: Internal, press Enter, and then choose either Enabled or Disabled from the dialog box.

Step 6 Press F10 to save and exit the utility.

Installing a Trusted Platform Module (TPM)

The trusted platform module (TPM) is a small circuit board that plugs into a motherboard socket and is then

permanently secured with a one-way screw.

TPM Considerations

• This server supports either TPM version 1.2 or TPM version 2.0.

• Field replacement of a TPM is not supported; you can install a TPM after-factory only if the server does

not already have a TPM installed.

• If there is an existing TPM 1.2 installed in the server, you cannot upgrade to TPM 2.0. If there is no

existing TPM in the server, you can install TPM 2.0.

• If the TPM 2.0 becomes unresponsive, reboot the server.

Installing and Enabling a TPM

Field replacement of a TPM is not supported; you can install a TPM after-factory only if the server does not

already have a TPM installed.

Note

This topic contains the following procedures, which must be followed in this order when installing and enabling

a TPM:

1. Installing the TPM Hardware

2. Enabling the TPM in the BIOS

Maintaining the Server

Enabling or Disabling the Internal USB Port

Cisco UCS C480 M5 Maintaining The Server

Other manuals for Cisco UCS C480 M5