Cisco UCS E Series User Manual

Figure 9: Inserting a Slot Divider into an SM Slot
Step 3 Push the slot divider in until it is fully seated. Slot dividers have a long retention screw that slides into the
divider. See the figure above.
Step 4 Tighten the retention screw on the front of the slot divider with a number-1 Phillips screw driver so that the
front surface of the slot divider is flush with the router panel.
Figure 10: Tightening the Slot Divider in an SM Slot
What to do next
What to Do Next
Install the E-Series Server or SM E-Series NCE into the router. See the “Installing the E-Series Server or the
SM E-Series NCE into the Router".
Removing the Slot Divider for Double-Wide E-Series Server Installation
To install a double-wide E-Series Server in the SM slot, you must remove the slot divider. Use this procedure
to remove the slot dividers from the SM slot.
Before You Begin
Make sure that you connect the wrist-strap clip to an unpainted portion of the chassis frame to channel unwanted
ESD voltages to ground.
Cisco UCS E-Series Servers and the Cisco UCS E-Series Network Compute Engine Hardware Installation Guide
28
Removing the Slot Divider for Double-Wide E-Series Server Installation

Cisco UCS E Series Specifications

General

Brand	Cisco
Model	UCS E Series
Category	Server
Language	English