Cisco UCS E Series User Manual

SD0
The SD0 card contains the Cisco Integrated
Management Controller (CIMC) software and must
always be present.
Note
2Memory DIMM slot1
CMOS battery (located under the daughter card)4Hard disk drive (located under the
daughter card)
3
EHWIC E-Series NCE LEDs
The following table lists the EHWIC E-Series NCE LEDs and describes the LED colors and states.
Table 17: EHWIC E-Series NCE LEDs
StateColorLED
• Steady—CIMC and the CPU are both operating normally.
• Blinking—The CPU is operating normally, and CIMC is booting up.
GreenPower
• Steady—CIMC is operating normally, and the CPU is powered down.
• Blinking—CIMC is in the process of booting up, and the CPU is powered
down.
Amber
Steady—Operation is normal.
Note
If DRAM is not detected, the SYS LED still displays solid green.
Note
• Blinking—System is booting before entering the EFI shell.
GreenSYS
Fault is detected on the processor.Amber
Left LED shows the condition of the traffic:
• Blinking—Traffic is detected.
• Off—There is no traffic.
GreenGE Port
LEDs
Right LED shows whether the link is established:
• Steady—Link is established.
• Off—No link is established.
Green
Basic Workflow for Installing the EHWIC E-Series NCE in the EHWIC Slot
Procedure
PurposeCommand or Action
Action
Step 1
Reference Topic
Step 2
Tools and Equipment Required for Installation,
on page 25
Gather the required tools and equipment.
Step 3
Cisco UCS E-Series Servers and the Cisco UCS E-Series Network Compute Engine Hardware Installation Guide
48
EHWIC E-Series NCE LEDs

Cisco UCS E Series Specifications

General

Brand	Cisco
Model	UCS E Series
Category	Server
Language	English