Always wear an ESD-preventive wrist strap and ensure that it makes good contact with your skin when you
remove or install DIMMs. Connect the equipment end of the wrist strap to the metal part of the chassis.
Caution
Handle the DIMMs by the edges only. DIMMs are ESD-sensitive components and can be damaged by
mishandling.
Caution
Only trained and qualified personnel should be allowed to install or replace this equipment. Statement 1030
Danger
Ultimate disposal of this product should be handled according to all national laws and regulations. Statement
1040
Danger
No user-serviceable parts inside. Do not open. Statement 1073
Danger
This unit might have more than one power supply connection. All connections must be removed to de-energize
the unit. Statement 1028
Danger
Blank faceplates and cover panels serve three important functions: they prevent exposure to hazardous voltages
and currents inside the chassis; they contain electromagnetic interference (EMI) that might disrupt other
equipment; and they direct the flow of cooling air through the chassis. Do not operate the system unless all
cards, faceplates, front covers, and rear covers are in place. Statement 1029
Danger
This section includes the following topics:
Memory DIMM Location
The following figure shows the location of the memory DIMMs in a single-wide E-Series Server.
The single-wide E-Series Servers support up to 16 GB of DDR3 memory DIMMs.
Note
Cisco UCS E-Series Servers and the Cisco UCS E-Series Network Compute Engine Hardware Installation Guide
41
Memory DIMM Location
To Next Page
Loading...
Need help?
General
