Cisco UCS E Series User Manual

Figure 25: Installing the Double-Wide EHWIC E-Series NCE in a Cisco ISR G2
ISR G22Double-wide EHWIC E-Series NCE1
Do not touch the EHWIC E-Series NCE board. Handle the EHWIC E-Series NCE by the edges of
the faceplate to reduce the risk of damage to the card.
Caution
Step 4 Using the faceplate, push the EHWIC E-Series NCE into place until you feel the EHWIC seat securely into
the connector on the router backplane. The interface card faceplate should contact the chassis rear panel.
Do not connect cables to EHWIC E-Series NCE until you have installed it.
Caution
Step 5 Using a number-1 Phillips or flat-blade screwdriver, tighten the captive mounting screws on the EHWIC
E-Series NCE faceplate.
What to do next
What to Do Next
1. Load a compatible Cisco IOS image.
2. Connect the EHWIC E-Series NCE to the network and then power up the router and the NCE.
3. Verify that the router recognizes the EHWIC E-Series NCE. See the Verifying EHWIC E-Series NCE
Installation, on page 53.
Cisco UCS E-Series Servers and the Cisco UCS E-Series Network Compute Engine Hardware Installation Guide
52
Installing the EHWIC E-Series NCE into the Router

Cisco UCS E Series Specifications

General

Brand	Cisco
Model	UCS E Series
Category	Server
Language	English