CBM-910 User’s Manual
CITIZEN
12
4.6 Paper End. Mechanical Alarm
(1) Paper end
Printing paper shortage is detected and informed with SEL lamp blinking at 0.5 second intervals, where printing is
suspended. At this time, power supply to the motor and printing solenoid is stopped with BUSY signals output in the
host computer.
To recover from Paper End state, set new paper and press SEL switch twice. LF functions normally.
By pressing SEL switch twice, you can print, without changing paper, data for one-line input buffer on the remaining
page.
(2) Mechanical alarm
On occurrence of locked motor, any kind of trouble in the mechanism is suspected. Power supply to the motor and
printing solenoid is stopped and BUSY signals are output in the host computer. SEL lamp is then blinked at 1/4
second intervals. To recover from alarm state, eliminate the trouble cause and press SEL switch twice.
If it is in the course of printing, printing is started at the beginning of the interrupted line. (Content of the input buffer
is still held.) However, this dose not apply to a case where power has been cut due to a severe trouble.
To Next Page
Loading...
Need help?
General
