27
2.7 Installing Interface Cap
(1) When Interface Cap
separated from the printer,
try to array the Cap Hook
in horizontal direction as
shown in the image.
(2) Using a sharp tool, insert
the Cap Hook to the hole
which is located in the right
side of Interface Cap.
(3) When Cap Hook inserted,
install the Cap Cover in
direction of an arrow as
shown in the image.
(4) Close the Interface Cap
cover.
V10 CONSUMIBLES S.L.
Calle Llanos de Jerez 18 Nave 9 Coslada https://v10consumibles.com Tel: 910 269 309
To Next Page
Loading...
Need help?
General
