Citizen CMP-40L User Manual

54
4. PRINTER ADJUSTMENTS
4.1 Setting the Sensor Mode
This menu sets sensor according to presently loaded paper stock (Gap,
Black Mark).
Set the sensor mode according to your supply as follows:
Sensor Mode Intended Use
Label Gap Use for die cut (no black mark) supplies.
Note:
If your supply is die cut with black marks, select
Black Mark Upper.
Black Mark Lower Use for supplies with black marks on the front (printing
side) of the supply.
Black Mark Upper Use for supplies with black marks on the back (non-
printing side) of the supply.
Peeler Use for receipt paper.
(1) Display the SETUP menu.
For details, refer to Menu operation examples on page 42.
(2) Press the Up (
) or Paper Feed/Down ( ) button to select the
items in the following order.
Sensors – Sensor Select
(3) Press the Up (
) or Paper Feed/Down ( ) button to select one
of four sensor modes: Label Gap, Black Mark Lower, Black Mark
Upper, Peeler.
SETUP
Label Gap
Black Mark Lower
Black Mark Upper
V10 CONSUMIBLES S.L.
Calle Llanos de Jerez 18 Nave 9 Coslada https://v10consumibles.com Tel: 910 269 309

Citizen CMP-40L Specifications

General

Brand	Citizen
Model	CMP-40L
Category	Printer
Language	English