56
4.2 Setting the Stock Sensor
This menu sets sensor level value for each sensor (Gap, Black Mark).
(1) Display the SETUP menu.
For details, refer to Menu operation examples on page 42.
(2) Press the Up (
) or Paper Feed/Down ( ) button to select the
items in the following order.
Sensors – Sensor Calibrate
(3) Conduct testing by referring to the following picture.
B/M & GAP SENSOR
PEELER SENSOR
4.2.1 Testing the Label Gap mode
(1) Turn the printer off, and then remove one or two labels from the liner.
With the printer in peel mode, place the liner over the sensor.
V10 CONSUMIBLES S.L.
Calle Llanos de Jerez 18 Nave 9 Coslada https://v10consumibles.com Tel: 910 269 309
To Next Page
Loading...
Need help?
General
