28
2.8
Setting/Replacing the Paper Roll
(1) Open the Paper cover by
pressing the Open button
and set the width of paper
guide by turning the knob
withnger.
(2) Put the stock in so it unrolls
from the bottom. Remove
the stock core when it is
empty. Pull a short length of
stock out of the printer.
(3) After inserting the paper,
adjust the paper guide to
little wider than paper size.
Then pull the paper out and
close the paper cover.
V10 CONSUMIBLES S.L.
Calle Llanos de Jerez 18 Nave 9 Coslada https://v10consumibles.com Tel: 910 269 309
To Next Page
Loading...
Need help?
General
