EasyManuals Logo
Home>CITROEN>Automobile>2015 Berlingo Multispace

CITROEN 2015 Berlingo Multispace User Manual

CITROEN 2015 Berlingo Multispace
293 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #50 background imageLoading...
Page #50 background image
48
Berlingo-2-VP_en_Chap03_Pret-a-partir_ed02-2015
Instruments and controls
Berlingo-2-VP_en_Chap03_Pret-a-partir_ed02-2015
Trip recorder zero
reset button
After this operation, if you wish to
disconnectthebattery,lockthe
vehicleandwaitforatleastve
minutes,otherwisethezerore-setwill
notberegistered.
Engine oil level indicator
Depending on your vehicle's engine,
when the ignition is switched on,
the engine oil level is indicated for
a few seconds, after the service
information.
Oil level
correct
Low oil level
Flashing of "OIL",
linkedwiththe
servicewarninglamp,
accompaniedbyan
audiblesignalandamessageinthe
screen, indicates a low oil level which
coulddamagetheengine.
Ifthelowoillevelisconrmedbya
checkusingthedipstick,itisessential
thatthelevelistoppedup.
Oil level gauge fault
Flashing of "OIL--"
indicates a
malfunctionofthe
engine oil level
indicator.ContactaCITROËNdealer
oraqualiedworkshop.
The level read will only be correct
if the vehicle is on level ground
and the engine has been off for
morethan30minutes.
Dipstick
A=maximum,neverexceed
this level as a surplus of oil
maydamagetheengine.
Contact a CITROËN dealer
oraqualiedworkshop
withoutdelay.
B=minimum,topupthelevel
viatheoilllercap,usingthe
grade of oil suited to your
engine.
Lighting dimmer
With the ignition on, press
the button until the zeros
appear.
With the lighting on,
press the button to vary
the brightness of the
instrumentsandcontrols.
When the lighting
reachestheminimum(or
maximum)setting,releasethebutton
then press it again to increase (or
reduce)thebrightness.
As soon as the lighting is of the
requiredbrightness,releasethebutton.
Zero reset
YourCITROËNdealeroraqualied
workshopcarriesoutthisoperation
aftereachservice.
However, if you carry out the service
yourself, the re-set procedure is as
follows:
- switch off the ignition,
- press and hold the trip recorder
reset button,
- switchontheignition.
Thedisplaybeginsacountdown.
When the display shows "=0", release
thebutton;thespannerdisappears.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the CITROEN 2015 Berlingo Multispace and is the answer not in the manual?

CITROEN 2015 Berlingo Multispace Specifications

General IconGeneral
BrandCITROEN
Model2015 Berlingo Multispace
CategoryAutomobile
LanguageEnglish

Related product manuals