130
CLUTCH
GEARBOX
TRANSMISSION
CHECKING AND ADJUSTING THE CLUTCH PEDAL TRAVEL
Turn the clutch adjustment nut "b" until you obtain the correct play B in the pedal.
After adjusting the play B in the pedal, check the height A of the pedal.
Tighten the parking brake lever and fit a wheel chock.
Start the engine and let it run at idle.
Without pressing the clutch pedal, bring the gear lever slowly into reverse gear until the gearing meets a
resistance from the clutch.
Progressively press on the clutch pedal and measure the travel from the point where the gear noise disappears
(point of release "c") to the position of maximum travel "d".
25 mm or more (from the position of maximum travel "d" to the point of release "c"
If the travel is not correct, proceed to the following operations:
Check the height A of the pedal
Check the play B in the pedal
Check the clutch mechanism and disc
Check the travel C of the pedal
Travel C of the pedal : 148 mm.
B2B2002D
B2B2003D
To Next Page
Loading...
Need help?
General
