140
CLUTCH
GEARBOX
TRANSMISSION
RECOMMENDATIONS / PRECAUTIONS : MMT PILOTED MANUAL GEARBOX
From the diagnostic tool menus, select :
« DIAGNOSIS »
MMT piloted manual gearbox.
Actuator test.
Gearbox actuator test.
Engage N (neutral).
NOTE : The letter «N» should appear on the instrument panel. If not, see the following solution:
Engaging of «N», without using a diagnostic tool..
Engaging of «N», without using a diagnostic tool.
In this configuration, the gearbox actuator is blocked, gear engaged.
NOTE : This recovery solution is to be used solely in a case where the attempt to make the gearbox
actuator engage b via the diagnostic tool has failed.
Preliminary operation:
Disconnect the battery negative terminal.
Remove the plug on the gearbox actuator.
"a" neutral.
"b" 1st, 3rd, 5th.
"c" 2nd, 4th, reverse gear.
Using a large screwdriver, move the screw (3) to place the gearbox actuator in the neutral position.
When this position is reached, position "N" is engaged.
B2C201TD
To Next Page
Need help?
General
