Draining methods.
Oil capacities are defined according to the following methods.
16
GENERAL
CAPACITIES (in litres)
Draining of the engine lubrication system by GRAVITY
Place the vehicle on horizontal ground
(in the high position if hydro-
pneumatic suspension).
The engine should be hot
(oil temperature 80° C)
.
Drain the sump by gravity
Remove the oil filter cartridge
(time for draining and drip-drip =
15 minutes approx.).
Refit the cap with a new seal
Refit a new oil filter cartridge
Refill the engine with oil
(see table for oil capacity).
Start the engine to fill the oil filter cartridge.
Stop the engine
(allow to stabilise for 5 minutes).
Draining of the engine lubrication system by SUCTION.
Place the vehicle on horizontal ground
(in the high position if hydro-
pneumatic suspension).
The engine should be hot
(oil temperature 80° C)
.
Remove the oil by suction through the dipstick tube.
Remove the oil filter cartridge.
Maintain the suction of oil in the sump
(15 minutes approx.).
Refit a new oil filter cartridge
Refill the engine with oil
(see table for oil capacity).
Start the engine to fill the oil filter cartridge.
Stop the engine
(allow to stabilise for 5 minutes).
WARNING : Remove the suction container before starting
the engine
ESSENTIAL : Systematically check the oil level using the oil dipstick.