13
GENERAL
GENERAL SPECIFICATION : LIFTING AND SUPPORTING THE VEHICLE
Note on status of the vehicle before lifting
The vehicle should be unloaded before any lifting operation. Never place a loaded vehicle on a jack or on a lift.
When you remove a heavy component, such as the engine or the gearbox, the vehicle’s centre of gravity moves.
Note on use of a 4-column lift
Respect the safety requirements set out in the user instructions.
Immobilise the vehicle with wheel locks.
Note on use of jacks and axle stands
Work on a flat surface and always use wheel blocks.
Use axle stands with rubber blocks "a", as indicated.
Place the jack and the axle stands on the prescribed lifting points on the vehicle. Do not use the jack without axle
stands.
To raise the front wheels, release the parking brake and place blocks at the rear of the rear wheels only. To raise
the rear wheels, place blocks at the front of the front wheels only.
To raise the front wheels only, or the rear wheels only, place blocks on either side of the wheels that are in contact
with the ground.
To relower a vehicle raised at the front, release the parking brake and place blocks at the front of the rear wheels
only. To relower a vehicle raised at the rear, place blocks at the rear of the front wheels only.
"b" : jacking point.
"c" : pantograph jacking point lugs.
"d" : centre of gravity of the vehicle (excluding load).
A:
3-door : OFFSET 331 mm LEVEL 1370 mm
5-door : OFFSET 349 mm LEVEL 1387 mm
E2A2001D
E2A2000D
Lifting and supporting the vehicle
To Next Page
Loading...
Need help?
General
