[SM-P00081-A]
―3―
● Consult CKD about the specifications before using the product outside the
designated specifications or for special applications.
● Turn off the power, stop the supply of compressed air and make sure that there is
no residual pressure before performing maintenance.
● Before increasing or decreasing the number of stations (valves) on the manifold,
turn off the power and release pressure.
● Thoroughly read and understand this Instruction Manual before removing or adding
a manifold solenoid valve.
● Thoroughly read and understand this Instruction Manual before working on
electrical wiring.
● Plan and perform daily and periodic inspections so that maintenance can be
managed properly.
● Check the working voltage and polarity before wiring and energizing.
● Turn off the power before wiring.
An electric shock may occur by touching the electrical wiring connection (bare live
part).
Do not touch live parts with bare hands.
● Thoroughly read and understand this Instruction Manual before working on
electrical wiring.
● Check the address setting value of serial transmission slave unit carefully before
use.
Improper address setting value may cause valves or cylinders to malfunction.
● This product does not meet the surge immunity requirements specified in
EN61000-4-5 for CE marking. Please provide appropriate protective measures
against lightning surges on the device side.
● Although the lamp on the valve may light up instantaneously when the valve power
is turned on, the valve itself will not be turned on or off.
WARNING
CAUTION
To Next Page
Loading...
Need help?
General
