ComAp InteliGen User Manual

4. Actual electric condition
5. RPM of the gen-set
6. Active power
7. Power factor
8. Timer – event’s counting time (e.g. prestart, cooling, …)
9. Signalizes, when any remote connection to controller is active
Following table contains an example of MINT and SPtM MEASUREMENT screens.
Other applications can be slightly different.
Measurement CU
MINT SPtM
Total power screen
30kW
0.90C
-20kW
1.00R
PWR I/E
-20
10kW
0.90L
Left up corner:
Actual power control mode None or Base or
Imp/Exp and required power values.
Load: Actual value of active power.
Actual value of PF
Mains: Actual value of active power.
Actual value of PF
Gen-set: Actual value of active power.
Actual value of PF
Generator (frequency, voltage)
Gen freq
Gen V1, V2, V3 ph-N (triple
bargraph)
Gen V12, V23, V31 ph-ph (triple
bargraph)
Generator (frequency, voltage)
Gen freq
Gen V1, V2, V3 ph-N (triple
bargraph)
Gen V12, V23, V31 ph-ph(triple bargraph)
Generator (current)
Gen I1, I2, I3 (triple bargraph)
Generator (current)
Gen I1, I2, I3 (triple bargraph)
Bus (frequency, voltage)
Bus freq
Bus V1, V2, V3 ph-N (triple bargraph)
Bus V12, V23, V31 ph-ph (triple
bargraph)
Mains (frequency, voltage)
Mains freq
Mains V1, V2, V3 ph-N (triple bargraph)
Mains V12, V23, V31 ph-ph (triple
bargraph)
Bus (current)
Im3/EarthFC (single bargraph)
Mains (current, power, PF)
Im3/EarthFC (single bargraph)
InteliVision 5, InteliVision 8 – Operator guide, ©ComAp – January 2014
IGS-NT Operator Guide 01-2014.pdf
45

ComAp InteliGen Specifications

General

Brand	ComAp
Model	InteliGen
Category	Control Systems
Language	English