IS-NT-Async-SPI, SW Version 1.2, ©ComAp – February 2011
IS-NT-Async-SPI-1.2.PDF
68
Gen-set power
Cylinder temperature
deviation from average
Max+CylDifPmin
Max-CylDifPmin
Max+CylDifPnom
Nominal power
PminCylDifEval
Max-CylDifPnom
+
-
Average temperature
Drawing text translation
Cylinder temperature deviation from average Cylinder temperature deviation from average
Average temperature Average temperature
Max+CylDifPmin Max+CylDifPmin
Max-CylDifPmin Max-CylDifPmin
PminCylDifEval PminCylDifEval
Max+CylDifPnom Max+CylDifPnom
Max-CylDifPnom Max-CylDifPnom
Nominal power Nominal power
Gen-set power Gen-set power
Service time 1 [ h ]
Service time 2 [ h ]
Service time 3 [ h ]
Service time 4 [ h ]
Running hours down counters are decremented when engine is running. Service alarm is indicated in Alarm
list and History record is activated when at least one of the counters reaches zero. Service time X setpoints
are actual counter values.
Step: 1 h
Range: 0 – 65535 h
Hint:
Once a service time has elapsed the corresponding Service time X setpoint must be adjusted again to a non-
zero value to clear the alarm and begin a new countdown.
You can rename the particular timers using Translator to indicate specific service intervals – e.g. “OilChange
time”, “SparkPlug time”, ...
Analog protect
The content depends on programmable protections settings. This list contains pre-set protections from
default archives:
Batt >V [ V ]
Warning level for battery over voltage.
Step: 0,1 V
Range: 8,0 – 40,0 V
Batt <V [ V ]
Warning level for low battery voltage.
Step: 0,1 V
To Next Page
Loading...
Need help?
General
