Comelit Vandalcom series User Manual

21
Data management using 1249B [NO VIP]
Entering a list (download)
Reading (upload) of the stored list
Software Art.1249B can be used to enter the list with Indirect Code and Code fields for INDIRECT CODE operating mode on
module 3070S. 3070S must be set to indirect code call mode (vedi “1.1.3. Call mode”).
INITIAL CONDITION
Module powered up in standby mode.
ENTER
USER CODE
PROCEDURE DISPLAY INFO DESCRIPTION
Connect the cable supplied with software Art.
1249B to terminals TX / RX / - (or D / D- if you
have an RS485 line).
ENTER
USER CODE
Run software Art. 1249B.
ENTER
USER CODE
On software 1249B with R.I. 003, the
CALL MODE must be set as Indirect Code
without a name entry.
Make the list with the Code and Indirect
Code entries in software Art. 1249B, or load
an existing list.
ENTER
USER CODE
Press the Download button in
software Art. 1249B.
DOWNLOADING...
COMPLETED
If the download was completed successfully.
Or
DOWNLOADING...
ABORTED
If an error occurred during the download.
Software Art.1249B can be used to read, inside module 3070S, the list with Indirect Code and Code fields for INDIRECT CODE
operating mode. 3070S must be set to indirect code call mode (see “1.1.3. Call mode”).
INITIAL CONDITION
Module powered up in standby mode.
ENTER
USER CODE
PROCEDURE DISPLAY INFO DESCRIPTION
Connect the cable supplied with software
Art. 1249B to terminals TX / RX / - (or D / D-
if you have an RS485 line).
ENTER
USER CODE
Run software Art. 1249B.
ENTER
USER CODE
Press the Upload button in
software Art. 1249B.
UPLOAD
COMPLETED
If the upload was completed successfully.
Or
UPLOAD
ABORTED
If an error occurred during the upload.

Comelit Vandalcom series Specifications

General

Brand	Comelit
Model	Vandalcom series
Category	Intercom System
Language	English