Limits
Fan, Macros
13
Limits
We have adjusted to the best settings for you out
of the factory,
if you do not know these parameters very well,
please do not change the parameters arbitrarily,
in case cause the printing failure.
1. Max Acceleration
2. Max Deceleration
3. Max Speed
4. Square Corner Velocity
Click the number on the right side of the value
bar to enter the value manually
Part Fan: can be controlled manually
The Fan_Board and hotend_fan are
uncontrollable, and will be turned on
automatically when the hotend starts
to heat up
You can view or test and run the
macro command
Fan Macros
To Next Page
Loading...