Change Configuration
Load/unload filament
1
2
3
1. If you want to change the printer
configuration, after entering the web
page by IP, click the “configuration”
option on the left menu bar
2. Click the "Printer.cfg" file (the one
without the date) to configure
3. After the configuration is complete,
click the "SAVE & RESTART" option
in the upper right corner (the klipper
system will restart)
18
1. Click *Extrude* on the home page.
3. Then insert the filament in to the
extruder, click * load*, the
extruder will load the filament
automatically, if you need
custom adjustment. click *
Extrude* , *Retract* , *Distance*
or * Speed* to adjust.
When the nozzle temp is so low,
it is not allowed to have related
operation about the extruder.
Please pre-heat nozzle first.
Each machine has been tested
before leaving the factory, and
it is normal to have residual
filament in the nozzle.
To Next Page
Loading...
Need help?
General