Command Light KNIGHT 2 Manual

KNIGHT2
22
Troubleshooting
Problem
Possible Cause
Solution
Unit will not extend
No power to the unit
Check power input
connections.
Incorrect installation
Refer to installation
instructions.
Upper stage will not
rotate
Lower stage not raised above
safety limit (16” above base)
Raise lower stage higher.
Rotation motor failure.
Consult with factory.
Lights will not illuminate.
Lower stage not raised above
safety limit (16” above base)
Raise lower stage higher.
Circuit breaker tripped.
Check circuit breaker at power
supply.
No power to the unit.
Check power supply
operation/output.
Lamp filament broken.
Replace lamp.
Rotation coasts after
switch is released
Rotation belt is loose.
Adjust belt to provide no more
than ¼” slack
Unit will not nest
Upper stage not centered.
Raise lower stage higher than
16”. Center upper stage (green
light illuminated)
Unit being operated on a slope
>15°.
Lower lamp tree to horizontal.
Using a pike pole, hold unit
level while lowering to nest
position.
Autopark button must be
held in to park unit
Faulty or stuck nest switch.
Check nest switch ground and
operation. Rubber boot may
have shrunk and is holding in
switch.
Water in electronics.
Remove moisture from ground
points and electronics. Do not
use a pressure washer to clean
unit.
Upper Actuator &
Rotation start at the same
time
Down limit switch stuck or
damaged.
Aluminum plunger which
activates down limit switch
should move freely. Verify
proper switch operation.
No lights or rotation
Check safety limit sensor, bad,
etc.
Contact factory for
replacement part.
Autopark is off Center
Center switch out of
alignment.
Refer to instructions on page
16.

Command Light KNIGHT 2 Specifications

General

Brand	Command Light
Model	KNIGHT 2
Category	Lighting Equipment
Language	English