RE-INSTALLiNGTHE CHUCK. AND ARBOR
C_ea_ the tapered surface on the arbor with a clean
cloth, Make sure there are no foreign particles stiCK-
_ng to the surface. The slightest piece of dirt on
th_s surface will prevent the arbor from seating
properly This will cause the drill to "wobble."
2, S_ide arbor inlo spindle on drilt press,
3. Push up on chuck/arbor assembly as you rotate
them. You wil! feel rectangular end of arbor slip
mto a notch in the spindle,
WARNING: Make sure the rectangular end of the 1
arbor has slipped into the notch in the spindle 1
before going on to step 4. Failure to follow this_
direction may allow the chuck to come iooseJ
during operation, fly out, and hit the operator. I
BODY
SPINDLE
CHUCK
4, Unlock support lock and raise table so its about
two (2) inches below tip of chuck.
5, Turn chuck sleeve clockwise and open jaws in
chuck completely,
6, Turn feed handles counterclockwise and force
ChUCk against table until arbor is secure,
SUPPORT
LOCK
\
CHUCK
SLEEVE
FEED
HANDLE
CHUCK
22
iii
To Next Page
Loading...
Need help?
General