/( i ¸¸
i! iiiiii!i!iii iii:i i!iiiiil) !i i ii ii)ii !ii ! i i , :ili i Iii!iiii i : !ii i : !ililiiii : ! i iiii i ii i:
10i Use °nly accessories designed for this drill 121 This Drill Press has 12 speeds as listed below:
Press to avoid se!ious injury from thrown bro; 250 RPM 990 RPM
pa_s or work pieces. 340 RPM i 550 RPM
cutting large dlameter holes: 390 RPM 1620 RPM
the workpiece iirmly to the tablel 510RPM 1900RPM
600 RPM 2620 RPM
Otherwise the cutter may grab and spin it at
high speed.
Use only one piece, Cup-type, hole cutters.
DO NOT use fly cutters or multi-part hole cut-
: ters as they can come apart or become unbal-
anced in use.
Keep speed below 1,500 RPM.
b. Drum sanders must NEVER be operated on
this drill press at a speed greater than 1800
RPM.
c. Do not install or use any drill that exceeds 7" in
length or extends 6" below the chuck jaws, They
can suddenly bend outward or break.
d, Do not use wire wheels, router bits, shaper cut-
ters, circle (fly) cutters or rotary planers on this
drill press.
11_ Note and Follow the Safety Warnings and in-
structions that Appear on the Panel on the
Right Side of the Head:
i " _WARNING
650 RPM 3100 RPM
See inside of belt guard for specific placement of
belt on pulleys.
13. Think Safety. Safety is a combination of operator
common sense and alertness at all times when the
drill press is being used.
WARNING: Do not allow familiarity (gained from]
frequent use of your drill press) to become com- I
monplace. Always remember that a carelessJ
fraction of a second is sufficient to inflict severe I
injury, j
The operations of any power tool can result in foreign
objects being thrown into the eyes, which can result
in severe eye damage. Always wear safety goggles
comply with ANSI Z87.t (shown on Package) before
commencing power tool operation. Safety Goggles
are available at Sears retail stores.
WEAR YOUR
To Next Page
Loading...
Need help?
General