6.Functional Specification
17
6.1 Filament Retreat
Method 1: Manual retract
① Input the nozzle temperature on the screen and wait for it to
heat up to the target temperature;
② A. Unlock the dip switch; B. Hold the Teflon tube connector above the extruder;
C. Pull out the Teflon tube;
③ Remove the old filaments by pulling them out from the back
of the machine to replace with new ones.
The current interface is for reference
only. Due to the continuous upgrading
of functions, it shall be subject to the
latest software/firmware UI published
on the official website.
A
B
C
To Next Page
Loading...
Need help?
General
