Example 2:
The CV2 Output Range is set to 32 as default. To change this to 64 for a 200% range instead do
the following. Presume that the instrument has not received any other messages and has not been
turned off since the last parameter change.
The NRPN Coarse message need not be set since it will retain its last value.
Send an NRPN Fine message with value 09 to select the CV2 Range parameter.
Send a Data Entry Coarse message with value 64 to set the new range.
Example 3:
The CV2 Output Range is now changed but is to be changed to 16 to provide 50% range instead.
The NRPN Fine message need not to be set since it will retain its last value.
·
Send a Data Entry Coarse message with value 16 to set the new range.
Routing the CV Outputs
CV outputs to the different modules are routed via switches on the
front panel and/or with patch cables.
Route with switches as follows:
·
Turn off the switch on the front panel that the CV output is currently using. Remove any patch cable that
might be connected.
·
Find the switch on the front panel that is to be used and select it.
Route with patch cables as follows:
·
Remove patch cable from the CV output that is currently in use and turn off any switch that is currently
used for the CV output.
Reroute the patch cable to the new CV output.
·
·
·
·
31
To Next Page
Loading...
Need help?
General