Table 1, Parameter Values
Parameter Function
NRPN Fine
Value
(NRPN
Coarse = 0)
Data Entry
Coarse Value
Comment
Base Note 01 0-127, default is 24
Lowest possible note
that will be played.
CV1 Function 02
CV1 is always handled as
main tune control. This
parameter currently has no
effect.
CV2 Function 03
0-127
Default is 121 for
Note-On Velocity
0-119, respond to
Control Change
messages with this
number.
120 = CV Output is
unused
121 = Note-On
velocity
122 = CV Output is
unused
123 = Accent
124 = Key Aftertouch
125 = Note-Off
velocity
126 = Channel
Aftertouch
127 = CV Output is
unused
CV3 Function 04
0-127
Default is 1 for
modulation wheel
controller
Same as for CV2
CV4 Function 05
0-127
Default is 124 for Channel
after touch
Same as for CV2
CV5 Function 06
0-127
Default is 5 for glide time
Same as for CV2
CV6 Function 07
CV 6 is always handled as
Pitch Wheel out. This
parameter currently has no
effect.
CV2 Range 09
0-63
Default is 32 which
provides 5V full swing at
data=127
63 provides x2, i.e. 5V at
data=64, and 16 provides
x0.5 i.e. 2.5V at data=127.
This can be viewed as 0-
200% scaling with about
5% resolution.
Scaling for
controllers, or
Scaling for velocity,
or
Scaling for aftertouch,
or
Accent trigg level
(Note that when
scaling is
programmed, values
larger than 32 will be
ignored and set to 32
instead)
CV3 Range 10
Same as for CV2
Same as for CV2
CV4 Range 11
Same as for CV2
Same as for CV2
32
CV5 Range
Same as for CV2
Same as for CV2
CV6 Range 13
Default is
12
from 0 to
±24 semitones ±24 semitones
To Next Page
Loading...
Need help?
General