D-Link DES-1008D User Manual

10/100 Dual-Speed Switch User’s Guide
16
Identifying External Components
Rear and Side Panels
The rear panel of the DES-1008D consists an DC power connector,
8 (10/100 Mbps MDI-X) ports, and 1 Uplink (MDI-II) port (shared
with port 1x). A description of the ports appear in the Introduction
of this User’s Guide (see Features, Chapter 1).
Figure 3.2 Rear panel view of the DES-1008D switch
Figure 3.3 Side panel view of the DES-1008D switch
♦ AC Power Adapter. This is a two-pronged external power
adapter that transforms AC current from the power outlet to
DC current to supply the switch. Plug in the female
connector of the provided power cord into this connector, and
the male into a power outlet. Supported input voltages for
the power adapter range from 90 ~ 230 VAC at 50 ~ 60 Hz.
The switch requires 5 VDC / 2.5 Amp.

D-Link DES-1008D Specifications

General

Switch type	Unmanaged
Switch layer	-
Power connector	DC-in jack
Installed SFP modules quantity	0
Basic switching RJ-45 Ethernet ports type	Fast Ethernet (10/100)
Basic switching RJ-45 Ethernet ports quantity	8
10G support	No
Full duplex	Yes
Networking standards	IEEE 802.3, IEEE 802.3x
Copper ethernet cabling technology	100BASE-TX, 10BASE-T
MAC address table	1024 entries
Product color	Black
Maximum data transfer rate	100 Mbit/s
Mean time between failures (MTBF)	116186 h
Input current	1 A
Output voltage	5 V
Package depth	158 mm
Package width	104 mm
Package height	94 mm
Package weight	310 g
Pallet width	1200 mm
Pallet length	1100 mm
Pallet height (air)	1885 mm
Pallet gross weight (air)	330500 g
Quantity per pallet (air)	1000 pc(s)
Shipping (inner) case width	211 mm
Shipping (inner) case height	350 mm
Shipping (inner) case length	543 mm
Shipping (inner) case weight	6230 g
Shipping (inner) case net weight	3960 g
Number of cartons per pallet (air)	50 pc(s)
Quantity per shipping (inner) case	20 pc(s)
Harmonized System (HS) code	85176990