3
Chapter 2 Hardware Installation
2.1 Panel Layout
2.1.1. Front Panel
Figure 2-1 Front Panel
M1&M2
System status indicators, Orange. M1 is flashed once per second to
indicate system is alive. When system is busy, M2 is lighted.
WAN & LAN
Ethernet port indicators, Green. The LED flickers when LAN or WAN port
is sending or receiving data.
Link/Act.
Link status indicators, Green. The LED flickers when the corresponding
port is sending or receiving data
10/100
10/100 status indicators, Green. The LED flickers when the corresponding
port is transmitting or receiving data in 10 or 100Mbps.
Port 1 - 4
LAN port socket (RJ-45). These are where you will connect to device on
your local area network, for example HUB and switch.
RESET
To reset system settings to factory defaults, please follow the steps:
1. Power off the device,
2. Press the reset button and hold,
3. Power on the device,
4. Keep the button pressed about 5 seconds,
5. Release the button,
6. Watch the M1 and M2 LEDs, they will flash 8 times and then
M1 flash once per second.
To Next Page
Loading...
Need help?
General
