D-Link DIR-412 User Manual

54D-Link DIR-412 User Manual
Section 3 - Conguration
Enter and conrm a new password for the Administrator
Login Name. The administrator can make changes to the
settings.
Check this box to enable graphical authentication. The
device supports this function to prevent phishing.
Remote management allows the DIR-412 to be congured
from the Internet by a web browser. A username and
password is still required to access the Web-Management
interface. In general, only a member of your network can
browse the built-in web pages to perform Administrator
tasks. This feature enables you to perform Administrator
tasks from the remote (Internet) host.
The port number used to access the DIR-412.
Example: http://x.x.x.x:8080 whereas x.x.x.x is the Internet
IP address of the DIR-412 and 8080 is the port used for the
Web Management interface.
Admin Password:
Enable Graphical
Authentication:
Enable Remote
Management:
Remote Admin
Port:
Administrator Settings
This page will allow you to change the Administrator and User passwords. You can also enable Remote Management. There are
two accounts that can access the management interface through the web browser. The accounts are admin and user. Admin
has read/write access while user has read-only access. User can only view the settings but cannot make any changes. Only the
admin account has the ability to change both admin and user account passwords.

D-Link DIR-412 Specifications

Operating Environment

operating temperature	0˚ to 40˚C (32˚ to 104˚F)
operating humidity	10%-95% (Non-condensing)

Power

power supply	DC 5V/2.5A +/- 5%

Weight and Dimensions

dimensions	122 x 97 x 27 mm