83D-Link DIR-505 User Manual
Section 3 - Conguration
Setup
Wireless Setup
Check the box to enable the wireless function. If you do not want to use
wireless, uncheck the box to disable all the wireless functions.
Service Set Identifier (SSID) is the name of your wireless network.
Create a name using up to 32 characters. The SSID is case-sensitive.
Select one of the following:
802.11g Only - Select if all of your wireless clients are 802.11g.
802.11n Only - Select only if all of your wireless clients are 802.11n.
Mixed 802.11n and 802.11g - Select if you are using a mix of 802.11n
and 11g wireless clients.
The Auto Channel Scan setting can be selected to allow the DIR-657 to
choose the channel with the least amount of interference.
Indicates the channel setting for the DIR-657. By default the channel is
set to 6. The Channel can be changed to t the channel setting for an
existing wireless network or to customize the wireless network. If you
enable Auto Channel Scan, this option will be greyed out.
Select the Channel Width:
Auto 20/40 - This is the default setting. Select if you are
using both 802.11n and non-802.11n wireless devices.
20MHz - Select if you are not using any 802.11n wireless clients.
40MHz - Select if using only 802.11n wireless clients.
Select Invisible if you do not want the SSID of your wireless network to
be broadcasted by the DIR-657. If Invisible is selected, the SSID of the
DIR-657 will not be seen by Site Survey utilities so your wireless clients
will have to know the SSID of your DIR-657
Enable Wireless:
Enable Auto Channel
Scan:
Wireless Network
Name:
Wireless Channel:
Channel Width:
Visibility Status:
Wireless Mode:
To Next Page
Loading...
Need help?
General
