74D-Link DIR-600 User Manual
Section 3 - Conguration
Time
Select the Time Zone from the drop-down menu.
Check this box if the country your are located in uses
Daylight Saving time. Enter a start date and an end date
for daylight saving time.
Click this button to synchronize the DIR-600’s system clock
to your computer’s time settings.
NTP is short for Network Time Protocol. NTP synchronizes
computer clock times in a network of computers. To enable
NTP carry out the following:
1. Check the Automatically synchronize with D-Link’s
Internet Time Server box.
2. Choose the D-Link NTP server that you would like to
synchronize with from the NTP Server Used drop-down
menu.
3. Click the Update Now button to update the time on the
Router clock so that it is synchronized with the D-Link
Internet Time Server.
Use this section to configure the time manually. To
congure the time manually, use the drop-down menus
to select the appropriate Year, Month, Day, Hour, Minute,
and Second.
Time Zone:
Enable Daylight
Saving:
Sync. Your
Computer’s Time
Settings:
Automatic
Time and Date
Conguration:
Set the Time and
Date Manually:
The Time window allows you to congure, update, and maintain the correct time on the internal system clock. From this section
you can set the time zone that you are in and set the Time Server. Daylight Saving can also be congured to automatically
adjust the time when needed.
Click the Save Settings button to save any changes made.