D-Link DIR-600 User Manual

43D-Link DIR-600 User Manual
Section 3 - Conguration
This will allow you to open a single port or a range of ports.
Port Forwarding
Tick the checkbox on the left side to enable the Port
Forwarding rule.
Enter a name for the rule or select an application
from the drop-down menu. Select an application
and click << to populate the elds.
Enter the IP address of the computer on your local
network that you want to allow the incoming service
to. If your computer is receiving an IP address
automatically from the router (DHCP), you computer
will be listed in the Computer Name drop-down
menu. Select your computer and click <<.
Enter the port that you want to open next to Public
Port and Private Port. The public and private ports
are usually the same. The public port is the port seen
from the Internet side, and the private port is the
port being used by the application on the computer
within your local network.
Select TCP, UDP, or All from the drop-down menu.
Use the drop-down menu to schedule the time
that the Port Forwarding rule will be enabled. The
schedule may be set to Always, which will allow
the particular service to always be enabled. You can
create your own times in the Tools > Schedules
section.
Enable Checkbox:
Name:
IP Address:
Public Port/
Private Port:
Trac Type:
Schedule:
Click the Save Settings button to save any changes made.

D-Link DIR-600 Specifications

Wireless Signal Rates

IEEE 802.11n 20MHz Channel	65/72.2 Mbps (max)
IEEE 802.11n 40MHz Channel	135/150 Mbps (max)
IEEE 802.11g	54 Mbps - 48 Mbps - 36 Mbps - 24 Mbps - 18 Mbps - 12 Mbps - 11 Mbps - 9 Mbps - 6 Mbps

Operating Environment

operating temperature	0 °C to 40 °C (32 °F to 104 °F)
storage temperature	-20 °C to 65 °C (-4 °F to 149 °F)
humidity range	10% to 95% (non-condensing)

Frequency Range

wireless frequency range	2.4 GHz to 2.4835 GHz (802.11g/n)

Weight and Dimensions

length	160 mm (6.3 inches)
width	120 mm (4.72 inches)
height	59 mm (2.32 inches)