43
5.8. Factory default
Set SipSet Phone to factory default.
5.9. Reboot
Reboot SipSet Phone.
6. WEB SETTING
Besides using the key menu on the telephone to carry on the basic configuration, but also you may use the WEB to carry on the comprehensive configuration.
6.1. How to land web
DPH-150S(SE) has two network modes: Bridge and Router, We can switch DPH-150S’s ( DPH-150SE’s ) mode between the two modes.（Default mode is
Bridge mode）
1、Bridge mode：
In bridge mode, two network interfaces have the same IP address called VOIP port IP address. User must ensure the interface (Network) close to DC has insert
line and the status is up. Then user can land the web through either interface.
User may use the network browser to visit the VOIP port IP address, landing the WEB configuration surface.
The VOIP port IP address can obtain from the telephone LCD menu：”Network setting -> IP address”. You may input http://xxx.xxx.xxx.xxx in the browser to
visit the web. “xxx.xxx.xxx.xxx”is the VOIP port IP address displayed in the telephone LCD menu and 80 is the web access port.
Also user can visit the web using https protocol, for example https://172.16.100.93
.
note：When you want to visit the VOIP port through the browser, please check your computer whether has connected correctly to the VOIP port and your computer IP
To Next Page
Loading...
Need help?
General
