118D-Link R12 User Manual
Appendix C - Networking Basics
Networking Basics
Check your IP address
After you install your new D-Link adapter, by default, the TCP/IP settings should be set to obtain an IP address from a DHCP
server (i.e. wireless router) automatically. To verify your IP address, please follow the steps below.
Click on Start and type cmd in the Search box.
At the prompt, type ipcong and press Enter.
This will display the IP address, subnet mask, and the
default gateway of your adapter.
If the IP address is 0.0.0.0 or empty, check your adapter
installation, security settings, and the settings on your
router. Some rewall software programs may block a
DHCP request on newly installed adapters.
To Next Page
Loading...
Need help?
General
