9
1.Press the ON/OFF button on the remote control to
turn the unit on; the On LED will light on the indoor
unit and “ON” will light in
the remote display.
2.Press the MODE button until the Heat
indicator appears in the display.
In the heat mode, the fan direction (UP,
DOWN) is further downward than that in
the cool mode for the good circulation.
TO SET UNIT TO HEAT MODE (ONLY HEAT PUMP MODEL)
To set the unit to heat the room to a desired temperature, follow the procedures below:
FAN SPEEDS
“AUTO” The fan will automatically select the fan
speed.
“” The fan will operate on low speed.
“” The fan will operate on medium speed.
“” The fan will operate on high speed.
“NATURAL” The fan will randomly cycle through the
speeds simulating a cool breeze.
3.Using the TEMP. ▼ or ▲ buttons, set the desired tem-
perature. The desired temperature can be changed up
to 32°C and down to 18°C.
4.To select the fan speed, press the FAN
SPEED button until the desired speed
appears in the display (see below).
NOTE:
When the heating orperation is started, hot air deliv-
ery might be delayed due to warm up period.
FAN DIR.
The air will flow up
First Press
and down.
Second
Normal air direction.
Press
1.Press the ON/OFF button on the remote control to
turn the unit on; the On LED will
light on the indoor unit and “ON”
will light in the remote display.
2.Press the MODE button to select the desired mode.
3.Press the FAN DIR. button to select the fan direction.
See chart below for detailed information on each of
the two settings.
To Next Page
Loading...
Need help?
General
