13
CHANGING/CLEANING THE AIR FILTERS
1. Open the indoor unit’s cover and remove both black
air filters by bending them slightly backward and the
lifting out.
2. Remove the two small filters (Deodorizing and
Electrostatic) from the indoor unit.
3. Examine the filters and determine if they need to be
cleaned or replaced. To clean filters, use a vacuum
and clean off dust. Use water and mild soap also if
necessary.
NOTE: The filters should be changed every 6 months.
If in a climate with cold winters, once a year is
adequate.
5. Insert cleaned or new black filters back into the unit.
4. Insert cleaned or new small filters (Deodorizing and
Electrostatic) back into the unit.
To change or clean the two black air filters, follow the procedures below:
INSTALLING THE REMOTE BRACKET
To install the remote bracket, insert one of the 2 supplied screws into top hole of the bracket and into the wall. Level the
remote bracket and insert the other screw into the bottom hole.
Insert the remote controller when not using it.
To Next Page
Loading...
Need help?
General
