12
1.Press the ON/OFF button on the remote control to
turn the unit on; the On LED will light on the indoor
unit and “ON” will light in the remote display.
2.Press the MODE button to select the desired mode.
Then, set the desired temperature using the TEMP.
▲ or ▼ buttons.
3.
Press the SLEEP button on the remote controller. The
unit will then be in the sleep mode and will cool the
room to the desired temperature. After a while the unit
will increase the temperature again.
This process will then repeat.
TO CANCEL SLEEP MODE:
To cancel sleep mode, press the SLEEP button again;
the SLEEP indicator will disappear in the display.
TO SET UNIT TO SLEEP MODE
When you are going to sleep, select this feature and the unit will cool off the room to the desired temperature and then
increase that temperature throughout the night.
1.Open the indoor unit’s cover and make sure the
EMERGENCY/REMOTE switch is set to the EMER-
GENCY position.
3.
To turn the unit off, slide the
EMERGENCY/ REMOTE
switch to the REMOTE position.
2.The unit will then turn on and depending on the room
temperature, it will select the cool or dehumidifier
mode, fan speed and fan direction automatically.
EMERGENCY OPERATION
If the remote control is lost, broken or has no batteries, follow the procedures below:
EMERGENCY/REMOTE Switch
EMERGENCY/REMOTE Switch
To Next Page
Loading...
Need help?
General
