7
1.Press the ON/OFF button on the remote control to
turn the unit on; the On LED will light on the indoor
unit and “ON” will light in the remote display.
2.Press the MODE button until the Quick (“”) indi-
cator blinks.
3.The unit will then start cooling or heating the room at
the highest power.
SET UNIT TO QUICK MODE
To set this unit to cool or heat (Heat pump model only) at the highest power, follow the procedures below:
1.Press the ON/OFF button on the remote control to
turn the unit on; the On LED will light on the indoor
unit and “ON” will light in the remote display.
2.Press the MODE button until the Cool indicator
appears in the display.
3.Using the TEMP. ▼ or ▲ buttons, set the desired tem-
perature. The desired temperature can be changed up
to 32°C and down to 18°C.
4.To select the fan speed, press the FAN SPEED button
until the desired speed appears in the display (see
below).
FAN SPEEDS
“AUTO” The fan will automatically select the fan speed.
“” The fan will operate on low speed.
“” The fan will operate on medium speed.
“” The fan will operate on high speed.
“NATURAL” The fan will randomly cycle through the
speeds simulating a cool breeze.
TO SET UNIT TO COOL MODE
To set the unit to cool the room to a desired temperature, follow the procedures below:
To Next Page
Loading...
Need help?
General
