C
O
M
P
O
N
E
N
T
Component 1 Component 2
27
Input Select
• Select [Component 1 or Component 2] by
pressing the “COMPONENT” button of the
remote control or using the “INPUT SELECT”
button of the PDP unit.
• Each time you press the “COMPONENT”
button, different input modes appear.
The sequence is as follows:
3
Select the Desired Channel and Function
• Select the desired channel and function
by using the remote control of the Digital
Broadcasting Receiver.
4
NOTES:
1) Possible digital broadcasting signals: 1080i, 720p, 576p, 480p.
2) Antenna connection:
Apartment : Check if communal aerial receives digital broadcasts.
Private Houses: Set the indoor/outdoor UHF antenna to the
direction of the digital broadcasting transmitting company.
3) For detailed connection method, refer to the owner’s manual of
Digital Broadcasting Receiver.
4) What is a component? : Signals with which luminance and
chrominance are separated, producing a sharp picture.
5) If the Digital Broadcasting Receiver has PC output terminal or DVI
output terminal, connect to ‘PC INPUT’ or ‘DVI INPUT’ at the rear of
the panel of the PDP.
• N.B.: You cannot select component inputs if the picture in
picture mode is on.
To Next Page
Loading...
Need help?
General