12
HOW TO INSTALL THE WASHING MACHINE
Selection of the Installing Place
Install the washer on the horizontal solid floor.
If the washer is installed on an unsuitable floor, it could make
considerable noise and vibration.
How to install on an Inclined Place
5. DIRECTIONS FOR INSTALLATION AND USE
Never install in these places.
• The place where it would be exposed to direct
sunlight.
• The place nearby a heater or heat appliances.
• The place where it would be supposed to be frozen in
winter.
• The kitchen with coal gas and a damp place like a
bathroom.
1. Height Setting
• After controlling the height by
turning the adjustable leg, let the
washer put down to the ground.
2.
Check the Horizontal Status
• Check the position of tub above
the center of the washer.
NOTES:
The opening must not be
obstructed by carpeting when
the washing machine is in-
stalled on a carpeted floor.
• The proper installation of the washing machine can
increase the wash effectiveness and the life of it.
If the washer is installed on an inclined floor, it could make considerable noise
and vibration and could cause a malfunction.
Use the height adjust rubber to adjust the washing machine so that it sits
properly.
In case that it goes over a
doorsill.
Don't let the height of the
drain hose exceed 20cm
from the gound.
Installing the Drain Hose [Non-pump Model]
¡
™
In case of extending the drain
hose.
Don't let the total length
exceed 3m.
Be careful that the end of the
drain hose is not immersed
in water.
To Next Page
Loading...
Need help?
General
