1
Mandatory
Mandatory
Forbidden
Ground cable
connection
Mandatory
Forbidden
Forbidden
Forbidden
8
The instructions described below are intended to prevent injury or damage to you and other people.
Possible conditions that may result from improper handling are classified as follows:
All these instructions include important information on safety. Be sure to observe the instructions.
After reading this manual, be sure to keep it in place so that users can read it whenever required.
If this product is transferred to another person, be sure to attach this manual to the product.
To use this product safely, be sure to observe the following instructions, and safety laws and regulations for the
relevant standards listed below.
Safety Precautions
Before using this product, read the following instructions carefully to ensure proper use.
This category indicates urgently
hazardous conditions that may
result in death or serious injury.
DANGER
This category indicates potentially
hazardous conditions that may
result in death or serious injury.
WARNING
This category indicates potentially
hazardous conditions that may result
in injury or property damage only.
CAUTION
Transportation, installation, piping, electric wiring,
operation, maintenance and inspection of the
unit must be conducted by qualified people.
Check the power supply (voltage, frequency and
current).
DANGER
1. Industrial Safety and Health Law 2. Fire Service Law 3. JIS B8361 General Rules for Hydraulic Systems
Precautions for installation
Only qualified people can handle the unit.
Connect the power cable according to the procedure
described in “Electric Wiring” on page
.
Connect the power cable according to the
procedure described in this instruction manual.
Check the weight of the unit with the nameplate
to make sure that it does not exceed the rated
load capacity of the carrier. Hang the unit by the
points specified in the outline drawing. Failure to
observe this instruction may result in fall or
overturn of the unit, causing injury or property
damage.
Check the weight, and hang the unit by the
specified points.
If the unit is not grounded, you may get an
electric shock.
Ground the unit securely.
Conduct electric wiring according to “Regulation
on Electrical Facilities” and “Internal Wiring
Regulations”. Improper wiring may result in
burnout or fire.
For overseas use, conduct electric wiring
according to the local wiring standard.
WARNING
Conduct electric wiring according to the
ratings.
Never get close to the unit when it is being
carried with slings. Failure to observe this
instruction may result in fall or overturn of the
unit, causing injury or property damage.
Keep away from the unit when it is being
carried with slings.
Do not climb on the OILCON when it is
transported or installed.
You may become trapped under the oil
controller due to the package falling.
Do not climb on the OILCON
(when it is packaged)
Check the fastening points with the outline
drawing, and fasten the unit securely with bolts
or foundation bolts. Failure to observe this
instruction may result in fall or overturn of the
unit, if this unit is installed at an elevated position.
Fasten the unit during operation.
Forbidden
If you install a duct at the exhaust port, the duct
may fall.
Do not install a duct
PIM00318A_EN.fm Page 1 Tuesday, October 26, 2010 12:37 PM
To Next Page
Loading...
Need help?
General
