SiUS091133 Indoor Unit: FTXS09/12LVJU
Removal Procedure 170
1.6 Removal of PCBs
Procedure Warning Be sure to wait for 10 minutes or more after turning off all power supplies
before disassembling work.
Step
Procedure Points
1. Remove the shield plate.
1
The figure shows the
appearance of the
electrical box.
Preparation
Remove the electrical box
according to the “Removal of
Electrical Box”.
2
Unfasten the hooks at
the upper 2 positions of
the shield plate.
3
Unfasten the hook at
the side of the shield
plate.
4
Lift up the shield plate
to unfasten the lower
hooks and remove it.
(R13747)
Signal receiver PCB
Control PCB
Display PCB
(inside)
Shield plate
INTELLIGENT EYE
sensor PCB
Shield plate
Hook (side)
Hook (lower)
To Next Page
Loading...
Need help?
General
