Danfoss DGS Series User Manual

5. Menu overview
Menu operation is done via a clear, intuitive and logical menu structure. The operating menu contains
the following levels:
• Starting menu with indication of the device type if no sensor head is registered, otherwise scrolling
display of the gas concentrations of all registered sensors in 5-second intervals.
• Main menu
• 5 sub menus under “Installation and Calibration”
Power On Time of the basic device
Count down in seconds until the communication between the hand-held
Service Tool and the DGS is established. In case of communication error the
countdown will stop.
“Warm-up Time” is displayed. As soon as the sensor warm-up time has
expired, the measured value is displayed = measuring mode.
When the warm-up time has expired, the display will show the
measurement value - see section 4.4.
Note: with 2 sensor variants the screen will alternate between the two
sensors every 5 seconds.
Seconds indicator = 0
After about 2 seconds
Power On Time
19 sec.
Danfoss
DGS
1 R744 ppm
Warm-up Time
Start menu
Main menu
Error Status
Alarm Status
Relay
Status
Measuring Values
Display
Parameters
Installation &
Calibration
Reading and acknowledgement of errors.
See chapter 5.1
Display of the status of active alarms.
See chapter 5.2
Display of the relay status. Protected by password.
See chapter 5.3
Display of measuring values.
See chapter 5.4
Read-out of hand-held tool version, language and set-up of
language. Partly protected by password.
See chapter 5.5
Reading and change of the relay, sensor head and
system parameters as well as test and calibration functions.
User Guide | Danfoss Gas sensor, type DGS
© Danfoss | Climate Solutions | 2022.01 BC291049702513en-000201 | 11

Danfoss DGS Series Specifications

General

Brand	Danfoss
Model	DGS Series
Category	Accessories
Language	English