Danfoss PVED-CLS Startup Guide

PVED-CLS vehicle geometry configuration P3421-P3428
Navigate to the vehicle geometry configuration section via System Navigator > Configuration >
Vehicle Geometry
Example parameter settings
If the parameter change is not described below or conditions are not met, use the default values.
Parameter Conditions for value changes
P3421 Set to match type of steering
P3422 Change according to wheel base figure shown below (dimensions measured in mm)
P3424 Change according to wheel base figure shown below (dimensions measured in mm)
P3426 Change according to steer angle figure and formula shown below (measured in degrees)
P3428 Change according to steer angle figure and formula shown below (measured in degrees)
Wheel base
Application Guide
PVED-CLS startup guide
Parameter setting
©
Danfoss | October 2018 AB285975085591en-000101 | 11

Danfoss PVED-CLS Specifications

General

Brand	Danfoss
Model	PVED-CLS
Category	Controller
Language	English